VEGA VEGASON 51P…53P Profibus PA - Manual (Page 40)

40 VEGASON 51P … 53P
Electrical connection
ESC ESC
+ -
OK OK
– +
+1 2- 5 6 7 8
Display Bus Addr. ON
8 7 6 5 4 3 2 1
Power supply and Profi-
bus signal
To the indicating instrument in the
sensor lid or to the external
indicating instrument VEGADIS 50
Version with Aluminium housing
- +
ESC
OK
Tank 1
m (d)
12.345
+ –
+1 2- 5 6 7 8
Display Bus Addr. ON
8 7 6 5 4 3 2 1
Power supply and
Profibus signal
Version with plastic housing
To the indicating instru-
ment in the sensor lid or to
the external indicating
instrument
M20x1.5 (diam-
eter of the
connection cable
6…9 mm)
M20x1.5 (diam-
eter of the
connection cable
6…9 mm)
Spring terminals (max.
2.5 mm
2 wire cross-
section)
Opening tabs
Pluggable
adjustment
module
MINICOM
5.3 Connection of the sensor
After mounting the sensor at the measure-
ment location according to the instructions in
chapter "4 Mounting and installation“, loosen
the closing screws on top of the sensor. The
sensor lid with the optional indication display
can then be opened. Unscrew the sleeve nut
and slip it over the connection cable (after
removing about 10 cm of insulation). The
sleeve nut of the cable entry has a self-lock-
ing ratchet that prevents it from opening on
its own. Now insert the cable through the cable entry
into the sensor. Screw the sleeve nut back
onto the cable entry and clamp the stripped
wires of the cable into the proper terminal
positions.
The terminals hold the wire without a screw
(spring terminals). Press the white opening
tabs with a small screwdriver and insert the
copper core of the connection cable into the
terminal opening. Check the hold of the indi-
vidual wires in the terminals by lightly pulling
on them.