VEGA VEGASON 51P…53P Profibus PA - Manual (Page 47)

VEGASON 51P … 53P 47
Setup
If the sensor address has been adjusted with
the DIP switch from 1 … 125, the address
number in the field "
Sensor address“ is grey
and cannot be changed at this point.
Create new measurement loop
• Choose the menu "C onfiguration/Measure-
ment loop/Modify“.
The menu window " Selection of measurement
loop - Modify meas. loop configuration“
opens.
• Here you choose the sensor to be config-
ured.
The measurement loops are listed as a se-
quence of sensor addresses with serial
number and any existing name.
• Choose in the window " Modify meas. loop
configuration“ the application and enter a
name for the measurement loop.
Parameter adjustment 1
In the menu " Instrument data/Parameter ad-
justment“ you carry out all important sensor
adjustments.
• Choose the menu "
Instrument data/Param-
eter adjustment“ and then the sensor on
which you want to carry out the parameter
adjustment.
In the opening menu window, you now see
the measurement loop names and descrip-
tions previously entered under "
Create new
measurement loop“. If you have only config-
ured or connected one sensor, there will
naturally be a choice of only one sensor.