VEGA VEGASON 51P…53P Profibus PA - Manual (Page 45)

VEGASON 51P … 53P 45
Setup
The adjustment program VEGA Visual Ope-
rating (VVO), called in the following VVO,
gets into contact with the connected sensor
…
… and asks in which mode the adjustment
software should be used. After a few sec-
onds, the software indicates if and with which
system a connection exists.
If the following message is displayed, you
have to change the communication settings in
VVO.
• Then click to "
Configuration“, point to "Pro-
gram“ and click to "Communication“.
• First click to "
Profibus DP (for PA sensors“.
Then choose the Profibus card which is
installed in your PC.
The window for the bus communication ad-
justments opens. Ten is preadjusted as ad-
dress for the Master-Class 2 interface card. If
participant number 10 is free in your bus, you
can accept address 10. Typical values of the
bus parameters have been preset. At this
point, you should adjust the communication
parameters that apply to your system.
• Now click to "
OK“.
The message " VVO will shut down and Win-
dows ® must be restarted“ appears.
Note: As a rule, a Windows ® restart is not
necessary.
• Now start VVO (restart).