VEGA VEGAFLEX 82 4 … 20 mA_HART two-wire Rod and cable probe With SIL qualification - Manual (Page 52)

52
7 Set up with the display and adjustment module
VEGAFLEX 82 • 4 … 20 mA/HART two-wire
44222-EN-130823
Menu item Default value Modified value
Status signals - Out of specification Switched off
Status signals - Maintenance Switched on
Device memory - Echo curve memory Stopped
Device memory - Measured value memory Started
Device memory - Measured value memory -
Measured values
Distance level, percentage value
level, reliability level, electronics
temperature
Device memory - Measured value memory - Re-
cording in time interval
3 min.
Device memory - Measured value memory - Re-
cording with measured value difference
15 %
Device memory - Measured value memory - Start
with measured value
Not active
Device memory - Measured value memory - Stop
with measured value
Not active
Device memory - Measured value memory - Stop
recording when memory is full
Not active
Additional adjustments
Menu item Default value Modified value
PIN 0000
Date Actual date
Time Actual time
Time - Format 24 hours
Probe type Device-specific
HART mode Analogue current output
The instrument settings are copied with this function. The following
functions are available:
•
Read from sensor: Read data from sensor and store into the
display and adjustment module
•
Write into sensor: Store data from the display and adjustment
module back to the sensor
The following data or settings for adjustment of the display and ad-
justment module are saved:
•
All data of the menu "Setup" and "Display"
•
In the menu "Additional adjustments" the items "Reset, Date/Time"
•
Special parameters
The copied data are permanently saved in an EEPROM memory in
the display and adjustment module and remain there even in case of
Additional adjustments -
Copy instrument settings