Chapter 7: roof assembly – Grain Systems Tanks PNEG-4075 User Manual
Page 104
Advertising
NOTE: Ensure that the orientation of the roof panel clip is correct, roof panel holes facing the roof
and the notch in the roof panel clip is facing the right-hand roof rafter.
3. Tighten all hardware to the recommended torque specifications only after the roof panels are
installed. See
Bolt Torque Specifications, page 24
Figure 7-27 Roof panel clip
A
Left-hand roof rafter (CTR-0207)
D
1/2 x 1-3/4 in. flange bolt (S-10252)
B
Roof panel clip (CTR-0214)
E
1/2 in. flange nut (S-10253)
C
Right-hand roof rafter (CTR-0207)
After You Finish
Repeat this procedure for the remaining roof panel clips.
104
Pneg-4075 75 Ft Diameter 40-Series Bin
Advertising