Sample gauge sheet – Grain Systems Tanks PNEG-4075 User Manual
Page 20
Guidelines for Placement of the Decal Sidewall Sheet
Use the following as a general guideline the proper decal sheet placement.
NOTE: Refer to the stiffener to sidewall attachment detail and specific gauge sheet for the bin. The decal
sheets are located in the third ring from the top. They are to be spaced evenly around the diameter
of the bin.
Figure 2-2 3 Post Bin with three rows of stiffeners used on each sidewall sheet
NOTE: Dashed lines represent stiffener locations.
Sample Gauge Sheet
A gauge sheet should be supplied with every bin and contains important information specific to your bin.
The gauge sheet contains the specific details that are unique to your bin. You must reference this sheet to
know the correct order to install the sidewall sheets and stiffeners. The gauge of the sidewall and stiffeners
are marked with colors for identification.
It is important to use the correct hardware for each type of connection. The gauge sheet will identify what
hardware should be used in a vertical seam, horizontal seam, and an overlapping seam for each gauge.
The gauge sheet will also identify the sidewall ring where the wind ring must be installed. This is indicated
by the word ”Standard” under the wind ring column and in the row of the ring it must be installed. If a side-
draw system is used, the word ”Additional” will be located in the row of the ring it must be installed.
Doors are to be installed in the ring or rings denoted with (D).
20
Pneg-4075 75 Ft Diameter 40-Series Bin