Installing roof exhauster assembly, Chapter 8: accessories – Grain Systems Tanks PNEG-4075 User Manual
Page 135
Figure 8-8 Roof exhauster assembly
A
5/16 x 1 in. hex bolt (S-10260)
D
5/16 in. flange nut (S-3611)
B
Roof exhauster hood
E
Exhauster mounting plate (CTR-0277)
C
Tube Caulk
F
Exhauster standoff weldment (MIS-7117)
Installing Roof Exhauster Assembly
The roof exhauster assembly replaces one of the roof flashing panels and allows for the roof exhauster to
be installed.
Before You Begin
IMPORTANT: Determine the location of the roof exhauster and remove the existing roof flashing panel at
this location. Install the peak-to-exhauster ladder kit next to the roof exhauster on the next
available rib. The location of the roof exhauster can vary. It should be installed in a location
that is free of obstructions, where it does not interfere with any other accessories on the
roof.
Pneg-4075 75 Ft Diameter 40-Series Bin
135