GE Industrial Solutions AF-650 GP General Purpose Drive (230V to 50HP, 460_575V to 100HP) - Manual (Page 36)

3.7.4 How to Connect a PC to the frequency converter
To control the frequency converter from a PC, install the DCT-10 Drive Control Tool
Software.
The PC is connected via a standard (host/device) USB cable, or via the RS485
interface as shown in the section Bus Connection in the Programming Guide.
NB!
The USB connection is galvanically isolated from the supply voltage (PELV)
and other high-voltage terminals. The USB connection is connected to pro-
tection earth on the frequency converter. Use only isolated laptop as PC
connection to the USB connector on the frequency converter.
Illustration 3.22: USB connection.
3.7.5 The DCT-10 Drive Control Tool Software
Data storage in PC via DCT-10 Drive Control Tool Software:
1. Connect a PC to the unit via USB com port
2. Open DCT-10 Drive Control Tool Software
3. Select in the “network” section the USB port
4. Choose “Copy”
5. Select the “project” section
6. Choose “Paste”
7. Choose “Save as”
All parameters are now stored.
Data transfer from PC to drive via DCT-10 Drive Control Tool Software:
1. Connect a PC to the unit via USB com port
2. Open DCT-10 Drive Control Tool Software
3. Choose “Open”– stored files will be shown
4. Open the appropriate file
5. Choose “Write to drive”
All parameters are now transferred to the drive.
A separate manual for DCT-10 Drive Control Tool Software as part of the software.
AF-650 GP Operating Instructions
35
3