GE Industrial Solutions AF-650 GP PROFINET - Manual (Page 54)

9.4 E.g.: PLC Programming
In this example PPO type 6 is placed in the following Input/Output address:
Illustration 9.2
Input address 256-257 258-259 260-261 262-263 Output
address 256-257 258-259 260-261 262-263
Set-up Status word MAV Motor torque Digital input Set-up Control word Reference Not used Not used
Table 9.7
This network will send a start command (047C Hex) and a
reference (2000 Hex) of 50% to the frequency converter.
Illustration 9.3
This network reads the motor torque from the frequency
converter. A new reference will be sent to the frequency
converter because the Motor Torque (86.0%) is higher than
the compared value.
Illustration 9.4
This network reads the status on the digital inputs from
the frequency converter. If digital input 18 is On it will
stop the frequency converter.
Illustration 9.5
Application Examples PROFINET Operating Instruction
53
9 9