Franklin Fueling Systems TS-LS300 AutoLearn Pressure-Based Electronic Line Leak Detector System Users Guide - Manual (Page 38)

WARNING
Serious legal, health, and safety hazards could result from not taking
the proper action within a specified time.
Where codes and regulations conflict with this manual, follow the regulations.
Compliance Reporting
The monthly or annual line leak testing requirements often vary from area to area.
It is the site owner’s obligation to know the frequency of line leak testing, the
compliance reporting requirements, and to comply with these requirements with
appropriate documentation. Compliance is determined by local/State / Federal Laws
and Regulations. Non-compliance may cause site shut-down, fines, or legal action.
The TS-TPI Turbine Pump Interface can also be wired to INCON TS-1001/TS-
2001automatic tank gauges (and other future models as developed), which could
provide all Tank and Line leak test Compliance Data automatically on a programmed
schedule to modems/fax machines at remote sites.
NOTE: The LS300 does not have a printer. You need to interface with the TS-1001 /
TS-2001 to print reports. Many localities require records showing the line tests are
passing. Hand-written records of the LED status can be recorded on a monthly
basis. Check with your local inspector to use this as a reporting method. See page
A6 for a form that can be used for recording TS-LS300 status.
5 Page 5-5
LS300 CONSOLE OPERATION
LS300 User’s Guide