AUMA Electric multi-turn actuators SA 07.1 - 16.1_SAR 07.1 - 16.1 MATIC AM 01.1 - 02.1 - Manual (Page 20)

10. Operation and indications of the local controls
Selector switch
Position OFF (0):
- No remote control possible
- No local control possible
- Actuator remains ready for signalization
signalization (the controls’ power supply is maintained)
Position Local control (I):
The actuator can be operated locally via the push buttons
OPEN - STOP - CLOSE.
Position Remote control (II):
The actuator can be controlled from remote, e.g. via the con-
trol room.
Position Test (III):
Test PTC tripping device (refer to page 27)
Only available in combination with motor protection
(PTC thermistor).
Yellow indication light (fault) is illuminated.
Position Reset (III):
Reset fault signal (yellow indication light) after the motor pro-
tection has tripped (refer to page 54).
Only available in combination with motor protection
(PTC thermistor).
20
Multi-turn actuators SA 07.1 – SA 30.1/ SAR 07.1 – SAR 30.1
with actuator controls AUMA MATIC AM 01.1 / AM 02.1
Operation instructions
Figure M: Local controls
Selector switch
Push buttons Indication lights
I I
0
I I
0
I I
0
Reset
III
Test
III
I II 0
Test
III
Reset
I II
III
0