Burkert Type 8645 - Manual (Page 130)

10 - 8645
CommissioninG
English
parameterisation of the individual module
Proceed as follows to parameterise a module:
Click with the right mouse key on the desired module, e. g. main/inside DI16/DO16.
Then select the point
Object properties (alternatively, double click on the desired module).
Select Parameter Assignment.
Illustration: Parameterisation of individual modules
Explanation of the device-specific parameters
parameters value Explanation
Error Behaviour Defines the status which the outputs go in the event of an
error (bus error).
Output: 0 All outputs are set to 0.
Hold last Value The last switching status before the error is maintained.
Switch replacement value The value indiacated under replacement value byte .. bit .. is
assumed.