5 inserting the supervisor board, Figure 3-3. jumper settings, supervisor board, Figure 3-3 – Micromod Micro-PWC: 53PW6000 MicroPWC Installation and Setup Manual User Manual
Page 28
Micro-PWC
™ Installation & Setup Guide
18 Installation
3.4.1.5 Inserting the Supervisor Board
This sub-section details the steps needed to insert the Supervisor board in the expansion slot of the per-
sonal computer on which the Micro-PWC system software will be installed.
Figure 3-3. Jumper Settings, Supervisor Board
J3
J4
J5
Base Address
AB
AB
AB
300H
AB
AB
BC
310H
AB
BC
AB
380H
AB
BC
BC
390H
BC
AB
AB
3A0H
BC
AB
BC
280H
BC
BC
AB
290H
✎ NOTE
The internal configuration of personal computers can vary between
models and between manufacturers. If you have questions about
the internal layout of your PC, or difficulty in following the steps
below, refer to the documentation that came with your computer.
∆ WARNING
The Supervisor board will be installed in a computer which
operates with possibly lethal voltages. Before removing the
computer cover, observe the precautions shown in
below, to provide personal protection and prevent damage to
the systems components.