Micromod Micro-PWC: 53PW6000 MicroPWC Installation and Setup Manual User Manual
Page 74
Micro-PWC
™ Installation & Setup Guide
64 @aGlance/IT Server Interface
8.1.3 Micro-DCI @aGlance/IT Server Requirements - Micro-PWC Version
The following requirements must be met in order to successfully run the @aGlance/IT API server:
•
TCP/IP must be installed on the node on which the @aGlance/IT server is to run.
On the Micro-PWC system, if a single channel Ethernet board is present and detected by the
Windows software during installation, the necessary TCP/IP software will be loaded
automatically. If the Ethernet board is not detected, or if a Supervisor board is present, the
TCP/IP software should be installed when it is prompted for during Windows software
installation.
•
A properly installed license for the @aGlance/IT API for Micro-DCI must be present. One
Micro-DCI @aGlance/IT Server Interface license is included with each set of Micro-PWC
system software. Additional licenses can be purchased.
On the Micro-PWC system, the user is prompted to enter license keys during the initial startup
of the system, as described in
of this Guide. After the initial startup, installation of
license keys is performed using the License Administration menu, described in
✎
NOTE If the license has not been installed for the Micro-DCI @aGlance/IT
server interface, it is still possible to use the @aGlance/IT
Administration Tool described in
. It will not be
possible to start @aGlance/IT servers on the Micro-PWC system,
however.