Agilent Technologies N5183A MXG - Manual (Page 245)

Agilent N518xA, E8663B, E44x8C, and E82x7D Signal Generators Programming Guide 235
Creating and Downloading Waveform Files
Programming Examples
// signal generator
char *filename = “C:\\Temp\\PSGTestFile”;
FILE *stream = NULL;
stream = fopen(filename, “w+b”);// Open the file
if (stream==NULL) perror (“Cannot Open File”);
int numwritten = fwrite( (void *)waveform, sizeof( short ), points*2, stream );
fclose(stream);// Close the file
// 3.) Load the internal Arb format file *********************************
// This process is just the reverse of saving the waveform
// Read in waveform as unsigned short integers.
// Swap the bytes as necessary
// Normalize between +-1
// De-interleave the I/Q Data
// Open the file and load the internal format data
stream = fopen(filename, “r+b”);// Open the file
if (stream==NULL) perror (“Cannot Open File”);
int numread = fread( (void *)waveform, sizeof( short ), points*2, stream );
fclose(stream);// Close the file
// If on a PC swap the bytes back to Little Endian
if( strcmp(computer,”PCWIN”) == 0 )
{
pChar = (char *)&waveform[0]; // Character pointer to short int data
for( i=0; i<2*points; i++ )
{
buf = *pChar;
*pChar = *(pChar+1);
*(pChar+1) = buf;
pChar+= 2;
}
}
// Normalize De-Interleave the IQ data
double IwaveIn[POINTS];
double QwaveIn[POINTS];
for( i=0; i<points; i++)
{
IwaveIn[i] = waveform[2*i] / 32767.0;
QwaveIn[i] = waveform[2*i+1] / 32767.0;
}
return 0;
}