Fairbanks H90-5200-A Digital Instrument - Manual (Page 12)

SECTION 2:
PROGRAMMING
A. Security Code “S.Code” Operation
If the security code is programmed with a value other than zero, the display will
indicate “S.COdE” when accessing the front panel programming. The operator must
enter the security code through the keypad and then press ENTER. The entered keys
will then be compared to the security code. If the correct security code has been
entered, the display will enter the appropriate programming routine, otherwise the
instrument will return to the weigh mode.
B. Programming Operating Parameters
When in the program mode, the value displayed at each step is the value currently
stored in the program. When in the programming mode, if a key is not pressed within
one minute, the instrument will time out and return to the weigh mode Some of the
keys and switches have special functions in the program mode.
These functions are defined as follows:
The ENTER key is used to store the displayed value in memory and advance to the
next program step.
The UP or DOWN arrow keys or the numeric keypad (0-9) can be used to change the
displayed value.
The GROSS / NET key can be used to immediately exit from most programming
menus.
To program the operating parameters, press the calibrations switch, SW3, located on
the main PC Board next to the load cell terminal block (standard programming), once,
or press FUNC 7 (front panel programming).
1. Program Steps
NOTE: If the programming mode is entered by pressing the SW3 switch, all of the
following programming steps can be changed. If the programming mode is
entered via the front panel, some steps may not be able to be changed
depending on the scales security level (selected in Step 15).
2. Program Number Display
This display will show the program number and revision level (P294X). This
information should be recorded for reference should any problems arise with the
operation of the scale. This is a nonprogrammable step.
50515 12 Issue #2 4/04