Fairbanks H90-5200-A Digital Instrument - Manual (Page 8)

a. FUNC 1: Setpoint key will access setpoint setup mode.
b. FUNC 2: 4-20 ma key will access the Smart 4-20 ma current
loop calibration mode.
c. FUNC 3: I/O key access the serial I/O setup mode.
d. FUNC 4: Accesses and displays time. A new time can now be
entered or ENTER can be pressed to keep the current time.
e. FUNC 5: Accesses and displays date. A new date can now be
entered or ENTER can be pressed to keep the current date
f. FUNC 7: Program key accesses and displays the current
operating parameters of the instrument.
g. FUNC 8: Instrument test. Shows security level, flashes A/D
counts, deadload counts, span counts, display test, RAM Test,
EE Prom Test, and Switch Test.
GROSS/NET: Switches weight display mode to Gross or Net, or used to
exit programming menu.
UNITS: Allows the displayed weight to be converted to new weight units
if the option was enabled.
AUTOTARE: Will set Tare memory equal to the Gross weight on the
Platform (which will then force the Net weight to zero). Auto tare must be
enabled and gross weight cannot be negative. Display will automatically
switch to Net mode, not maintained at power loss.
ZERO: Will set the Gross weight equal to zero provided the weight to be
zeroed does not exceed the programmed zero range.
PRINT: Causes the instrument to transmit information to the output
device if enabled.
CLEAR: This is a dual function key. The first time it is pressed it
produces a decimal point. Pressing the key twice “CLEARS” the last
entry made.
KEYPAD: Keys “0” through “9” and “.” and “ENTER” are used to
enter Tare, programming codes, setpoints, etc.
50515 8 Issue #2 4/04
FUNC
FUNC
FUNC
FUNC
FUNC
FUNC
FUNC
1
SET PT
2
4-20mA
3
I/O
4
TIME
5
DATE
7
PROG
8
TEST
"
AUTO
TARE
GROSS
NET
"
1 2 3
4 5 6
0
7 8 9
O/U
PRINT
CLEAR