Fairbanks H90-5200-A Digital Instrument - Manual (Page 26)

Programming Setpoint Values
1. Press FUNC, 1. The display will show “SP CAL” Enter the number of the setpoint
you wish to program, 1 – 5. If paired setpoints are used (dribble is enabled), then
enter 1 or 3 to program the setpoint value and 2 or 4 to program the dribble value.
Always enter 5 to program Setpoint Software Inhibit.
2. The selected setpoint indicator will turn ON and the display will alternately flash
between a legend and the current value programmed. The legend will be “SP” for
setpoint, “DR” for dribble, or “SPi” for setpoint software inhibit, or “2b” for zeroband.
3. Enter a new value from the keypad or press ENTER to store the current value in
memory.
4. If Preact is enabled, the instrument will now prompt the user to enter the Preact
value to be used. There is a separate preact available for each output.
5. The unit will now return to normal weigh mode.
SETPOINT Outputs
The setpoint output terminal block, is located in the bottom of the instrument. The
setpoint output cable is connected to J3 (pins 10-16) on the main PC Board, near the
AC power connector.
The setpoint control cable will exit the instrument through the waterproof gland on the
back (see Figure 2417, page 11). Refer to Appendix VII to identify setpoint outputs at
TB3.
50515 26 Issue #2 4/04
Power
Supply
1
1
1
24 13
12
JP1
JP2
JP7
JP6
JP3
1
1 1
7
14 8
Load Cell
Connector
50514-2
6 7 8 9 11 12 13 14 15 16
J3
1 2 3 4 5
RS232 C. Loop Set Points