Fairbanks H90-5200-A Digital Instrument - Manual (Page 32)

Discharge cycle starts IF enabled
ENTER ID <STX>EIXXXXXX<CR><ETX>
Product ID is entered into memory (XXXX =ID is desired)
RECALL ID <STX>RI<CR><ETX>
ID is output
ENTER TARE <STX>ETXXXXXX{L / K}<CR><ETX>
Tare is entered into memory. IF an illegal tare is used, it will be
cleared. L(LB) OR K(KG) can be used to request output in a
specific weight unit
RECALL TARE <STX>RT{L/K}<CR><ETX>
Tare is output.
L(LB) OR K(KG) can be used to request output in a specific
weight unit
RECALL CONFIG <STX>RC<CR><ETX>
Config/Calibration parameters are output
ENTER SETPOINT <STX>ESM[x][NI][Dy][Py][Cy][Zy][lz][Ay][T1xx][T2xx][Oy]<CR><ETX>
RECALL CONFIG <STX>RC<CR><ETX>
Model, Progam Rev,Time, Date, Cap, Cal Data: Current
Zero______S________ Diag Test 1_______2_______
Note: ONLY 7 variables can be entered at one time
C =Discharge/Dump
I =Setpoint Inhibit
A =Auto zero at batch start
O =Output (Autoprint)
T1 =Delay Timer1
T2 =Delay Timer2
M =Mode
x =0 (Setpoints disabled)
x =1 (Setpoint mode)
x =2 (Checkweigh mode)
x =3 (Batch mode)
x =4 (Autobatch mode)
x =5 (Autobatch repeat mode)
x =Anything else (Setpoints disabled)
N =number of ingredients
I =1,2,3,4
D =Dribble
P =Preact
Z =Zeroband
50515 32 Issue #2 4/04