Fairbanks H90-5200-A Digital Instrument - Manual (Page 6)

Auto Batch mode available with dribble, preact, discharge, zero band, setpoint
inhibit, setpoint auto zero, delay 1, and print.
Auto Batch Repeat mode available with the same features as Auto Batch but
includes delay 2.
19. Serial output: One bi-directional serial port, which may be configured for RS-232 or
20mA current loop. Selectable BAUD rates are 300, 600,1200, 2400, 4800, 9600,
and 19200.
20. Power: 100-130 VAC, 50/60 HZ 10 watts standard
200-250 VAC, 50/60 HZ 10 watts optional
Options:
Accessories:
a. Second Serial Output:
Accessory 145 (1-57364-1) - Output configured for 20mA current loop
Accessory 146 (1-57365-1) - Output configured for RS-232
Accessory 147 (1-57401-1) - Output configured for RS-422 or RS-485
b. Accessory 148 (4-57402-1) - SMART 4-20mA analog output. Output can
also be configured for 0-20mA, or 0/1-5VDC, 0-10VDC with customer supplied
resistor.
NOTE: One Accessory, A or B can be used , NOT BOTH.
c. Accessory 149 (4-57568-1) - NEMA 12 Relay Accessory. Accessory can be
attached to instrument or remote mounted. Accessory is driven by setpoint
outputs and provides (4) Form C contacts rated at 5 Amps @ 250 VAC or 5
Amps @ 30 VDC.
d. Accessory 150 (701138) - Cable for remote mounting of Accessory 149 or
Accessory 151, up to 100 ft from the instrument
e. Accessory 151 (4-57838-1) - NEMA 4 Remote Relay Accessory Accessory
is driven by setpoint outputs and provides (4) Form C contacts rated at 5 Amps
@ 250 VAC or 5 Amps @ 30 VDC.
f. Pillar Accessory - The H90-5200-A is compatible with all Series 7 Pillar
Accessories
50515 6 Issue #2 4/04