Fairbanks H90-5200-A Digital Instrument - Manual (Page 30)

“di” date and ID
‘ti” time and ID
“I” ID only
“td” time and date
“d” date only
“t” time only
“no tdi” no time, date, or ID
Use the UP or DOWN arrows to scroll through the selections, Press ENTER to select.
The display will show “nEt” or Gtn’ If “nEt” is selected, the instrument will output NET
weight only in the Net weigh mode If “Gtn” is selected, the instrument will output
GROSS, TARE and NET weight in the Net weigh mode. The instrument only outputs
GROSS weight in the Gross mode. Use UP or DOWN arrows to toggle between the
choices. Press ENTER to select.
The display will show “CrLF” for carriage return and line feed or “Cr” for carriage return
only at the end of each line. Use UP or DOWN arrows to toggle between the choices .
Press ENTER to select.
For Label Printer ONLY, select “bar” / “no bar”. (bar = code 128 label, no bar = human readable
label)
e. When a computer format is chosen (at step C) , an option of enabling <STX>
and <ETX> for computer commands must be set. The display prompt will
show” St Etx”, where x is a “1” or a “0”.
Select “1” to enable <STX> and <ETX> for computer commands.
This completes the output programming and the display will return to the weigh mode.
All serial outputs are programmed the same. Switching from RS-232 to the current
loop or RS-485 is controlled by hardware. Refer to Appendix II.
3. Serial Output Data Format
Refer to Appendix V.
4. Wiring Diagram For Data Output
Refer to Appendix IV.
H. Computer Commands
Note: The option of eliminating the <STX> and <ETX> can be selected. This is
useful in “backwards compatibility” with the 5200 instruments. It is strongly
recommended to use the <STX> and <ETX> when using RS485.
1. * The COMMAND FORMAT is <STX>[ID]CMD<CR><ETX> where:
[ ] = Optional parameters
ID = 1-3 Digit ID (1-255)
CMD = Command
<STX> = Start of Text char
<ETX> = End of Text char
50515 30 Issue #2 4/04