Fairbanks H90-5200-A Digital Instrument - Manual (Page 3)

Table of Contents
SECTION 1: DESCRIPTION
A. Introduction 4
B. Specifications 4
C. Keypad Description 7
D. Indicator Description 9
E. Back Panel Description 9
F. Basic Weighing Operations 9
G. Power-Up Test 11
SECTION 2: PROGRAMMING
A. Security Code “S.Code” Operation 12
B. Programming Operating Parameters 12
C. Displaying and Setting Time 16
D Displaying and Setting Date 17
E. Test Mode 17
F. SETPOINT Operation And Programming 18
G. Serial Output Operation and Programming 27
H. Computer Commands 30
I. Computer Command Protocol 33
J. Programming the SMART 4-20mA Analog Loop 33
SECTION 3: INSTALLATION
A. Instrument Mounting Options 36
SECTION 4: TROUBLESHOOTING
A. Troubleshooting 37
APPENDIX I: Quick Reference Chart 38
APPENDIX II: Serial Output Installation 39
APPENDIX III: Switch Settings for Selected Printers 42
APPENDIX IV: Wiring Diagram for Serial Outputs 47
APPENDIX V: Serial Output Data Format 49
APPENDIX VI: Wiring Diagram for Smart 4-20 Output Accessory 51
APPENDIX VII: Setpoint Outputs VS. Calibration 52
APPENDIX VIII: Pillar Accessory lnstallation 53
APPENDIX IX: ASCII Character Chart 54
APPENDIX X: Keyboard Schematic / Wiring Diagram 55
APPENDIX XI: Remote Switch 56
APPENDIX XII: Summary of Error Messages 58
APPENDIX XIII: Wall Mounting Bracket 59
APPENDIX XIV: Print Samples 60
DISCLAIMER
Every effort has been made to provide complete and accurate information in this manual. However, although this
manual may include a specifically identified warranty notice for the product, Fairbanks Scales makes no
representations or warranties with respect to the contents of this manual, and reserves the right to make
changes to this manual without notice when and as improvements are made to the product.
50515 3 Issue #2 4/04