Fairbanks H90-5200-A Digital Instrument - Manual (Page 16)

NOTE: When a switch that has been disabled/inhibited is pressed,
the display will momentarily flash “Error”.
18. Remote Switch Enable
Three (3) remote or external switches can be used to emulate only the following keys,
ZERO, START, PRINT, AUTO TARE,TRIM, TARE RECALL, UNITS, STOP. All remote
switches must be momentary dry contact type (without power), and are hard wired to
the optically isolated 10 position connector, TB3 on the main board. See Appendix XI
for wiring diagram.
a. Display will read: “rS 0” where rS means remote switch and 0=OFF. By
pressing”1”then “enter” the display will read”rS 1 “and enable this function.
b. The display will read “rS1 ” which means remote switch 1 is enabled for
the ZERO function.( See chart of key symbols in APPENDIX XII). To
change, press the key you wish to be remotely controlled and press “enter”.
c. The display will advance to show “rS2 A” meaning remote switch 2 is set
to function as an AUTO-TARE key. Change as required by pressing the
key you want to emulate, then press “enter”.
d. The display will advance to show “rS3 P” meaning remote switch 3 is set
to function as a PRINT key. Change as required by pressing the key you
want to emulate, then press “enter”.
e. After “enter” is pressed for “rS3 X”, the display will return to the weigh
mode
C. Displaying and Setting Time
1. From a gross or net weight display, press FUNC, the display will indicate
“Func”.
2. Press the 4 key.
3. The display will indicate the current time where “A” stands for AM and “P”
stands for PM (e.g. “11:36 AM will be shown as “1136 A”).
If the time was set in 24 hour military format (00:00 thru 23:59), the AM or
PM legends will not be shown.
4. Press ENTER if time is correct The display will return to the weigh mode or
enter the correct time by pressing the numeric keys “0” through “9” .Enter the
hours first and then the minutes (see example).
The time must be entered in 24 hour military format (0000 through 2359).
Example: Military Time Setting
To set the time to 8:49AM, enter “849”. To set 8:49 PM, enter “2049”.
Do not enter leading 0’s.
5. When the correct time is entered, press the ENTER key to store the
displayed time.
50515 16 Issue #2 4/04