Rapid-Air CUT-TO-LENGTH WITH MULTI-STROKE User Manual
Page 11
Cut to Length with Multi Stroke Program
INTERFACING SERVO FEED WITH A CUTTER
The servo drive unit is programmed to feed each time a signal is received
from the cutter switch. The servo will feed one progression and wait for the
next signal before it will feed again in automatic mode.
The command is in the form of a normally open contact from a proximity
switch located on the cutter and is activated when the cutter is returned.
If the feed/cutter was purchased complete then the interfacing was done for
you. If not then Rapid-Air has provided wiring to a terminal block for
interconnection purposes. The interface schematic provides the wire numbers
and how to connect the cutter to the feed.
This completes the initial setup of the servo feed to the cutter or other device.
The servo is now ready to run as intended.
If more complete interfacing is needed, please refer to the section (interfacing)
in this manual for an explanation of inputs and outputs available.
PRETEST FOR SERVO FEED AND CUTTER WITHOUT MATERIAL
file:///C|/Web_develop/cut_to_length_with_multi_stroke_.htm (10 of 66) [12/10/2001 3:44:57 PM]