Rapid-Air CUT-TO-LENGTH WITH MULTI-STROKE - Manual (Page 47)

Cut to Length with Multi Stroke Program
F3=AUTOMATIC CYCLE
F4=REVIEW JOB PROGRAM
F3=AUTOMATIC CYCLE
If the feed has been properly set up, tested in manual, press electrically
interlocked with feed, feed and pilot switches wired to the correct terminals,
then pressing the F3 key will display the following screen.
START AUTOMATIC FROM
F1=SEQUENCE NUMBER 1
F2=PREVIOUS SEQUENCE
AND REPEATS POSITION
After selecting one of the above choices the following screen appears.
SELECT CONTINUOUS OR
BATCH CYCLE F1=BATCH
F2=CONTINUOUS CYCLE
F4=EXIT TO MAIN MENU
file:///C|/Web_develop/cut_to_length_with_multi_stroke_.htm (46 of 66) [12/10/2001 3:44:58 PM]