Rapid-Air CUT-TO-LENGTH WITH MULTI-STROKE - Manual (Page 43)

Cut to Length with Multi Stroke Program
After pressing the F4 key and the parameters are within the operating range,
the following screen appears.
JOB#=00 SEQUENCE=00
FL=000.000 REPS-0000
PUSH ENTER TO SELECT
F4=PROGRAM NEXT STEP
This screen will repeat for all the sequences selected. Press enter key to
move from FL, repeat, outputs and pilots. Press F4 key when all sequence
parameters have been entered. When complete, the main menu will appear.
If a feed rate is entered that is too long for the SPM then a fault screen will
appear as previously described.
In order to advance material into the cutter, using the servo feed, the operator
has to be in the manual mode. Pressing the F2 on the keypad will cause the
screen to change to the manual mode screen. (Cycle rolls with keys) - If the
keypad has keys with open rolls or close rolls on it then the keys are active at
this time and the rolls can be electrically released for inserting the material into
the servo feed.
MANUAL MODE F1=INCH
F2=SINGLE FEED MODE
file:///C|/Web_develop/cut_to_length_with_multi_stroke_.htm (42 of 66) [12/10/2001 3:44:58 PM]