Rapid-Air CUT-TO-LENGTH WITH MULTI-STROKE - Manual (Page 54)

Cut to Length with Multi Stroke Program
the sequence would be changed in the job memory for any future running of
the job. The repeats, outputs, pilots, speed and accel can also be adjusted at
this time. When finished, press the F4 key and the main menu screen will be
displayed.
The last section to be covered is the ramp/counters section. To get into this
mode, press the ramp pushbutton and the following screen appears.
SELECT RAMP/COUNTERS
F1=BATCH/TOTAL COUNT
F2=ALTER ACCEL/SPEED
F4=EXIT TO MAIN MENU
F1=BATCH/TOTAL COUNTS
Pressing the F1 key will bring up the batch/total screen, which is used for
presetting the batch count or resetting the total count. The following screen
appears.
BATCH COUNTER=000000
TOTAL COUNTER=000000
SET:F1=BATCH F2=TOTAL
file:///C|/Web_develop/cut_to_length_with_multi_stroke_.htm (53 of 66) [12/10/2001 3:44:58 PM]