Rapid-Air CUT-TO-LENGTH WITH MULTI-STROKE - Manual (Page 17)

Cut to Length with Multi Stroke Program
F. AUTOMATIC OUTPUT (J52)TB2-11)
This output must be tied to a solid state relay to interface to the outside world.
The solid state relay must have a D.C. coil and should have a rating of 3-30
VDC. The Rapid-Air #69100165 is recommended for this application. This
output goes high whenever automatic is selected on the program panel. Any
faults will cause the automatic output to go low.
G. KEYPAD AND DISPLAY INTERFACE (RS232 PORT)
The keypad/display is the interface between the operator and the resident
program. The Pacific Scientific drive is purchased with a great many
capabilities, none of which can be used unless a program is written to utilize
these capabilities. Rapid-Air put a great deal of time making a program that is
user friendly and yet gets the job done efficiently. We took all the questions
and constructive criticism and came up with a program that would cover all the
applications, yet be easy to interface and program by a customer.
H. STANDARD PROGRAM-INSTRUMENTS INTERFACE (J52)TB1-14)
With the jumper in place, the standard program is active. Remove jumper,
recycle power and the Data Instruments is active. Only the manual mode will
work with the keys at this time.
If an operator reads the programming procedure in this manual and then
reads the screen parameters listed as they are displayed and acts on them by
inputting data as needed, the servo can be up and running in a very short
time.
file:///C|/Web_develop/cut_to_length_with_multi_stroke_.htm (16 of 66) [12/10/2001 3:44:57 PM]