Rapid-Air CUT-TO-LENGTH WITH MULTI-STROKE - Manual (Page 23)

Cut to Length with Multi Stroke Program
material tracking seems to be a problem then this could be a way of solving
the problem. To test if the rolls need adjustment, do the following.
1. Remove the front and rear roll covers.
2. Raise the anti-backup rolls. (If any) main rolls should be closed.
3. Shine a light from the rear of the feed toward the main rollers.
4. Inspect from the main rolls side to see if the rollers are parallel. If they are
then the material could be the cause of the material walking. If they are not
parallel then an adjustment has to be made.
5. To make the adjustment:
a. Remove manual roll release arm by removing roll pin.
b. Remove belt cover.
c. Locate eccentric screw and loosen 10-32 screw.
d. Turn slotted eccentric screw while viewing rolls until the rolls are parallel.
For a more accurate adjustment use a feeler gage to check the parallelism.
e. Tighten 10-32 screw and reassemble parts, then retry running material.
This completes the eccentric adjustment write-up, if there are further
questions, please call the factory.
file:///C|/Web_develop/cut_to_length_with_multi_stroke_.htm (22 of 66) [12/10/2001 3:44:57 PM]