Rapid-Air CUT-TO-LENGTH WITH MULTI-STROKE - Manual (Page 7)

Cut to Length with Multi Stroke Program
time, are all that is required for a new setup. Routine jobs can be stored,
recalled, changed, saved or run with a simple 2 digit job number entry. Up to
10 jobs may be stored and recalled at will.
A resolver, direct coupled to the servo drive motor for precise digital position
feedback, enable roll positioning accuracy to +/-.0025 for any programmed
feed length or speed.
Operator can program feed lengths, up to 999.999 inches and % max speed
selection along with full jog features on a pendant unit. Allow the operator to
thread the material and inch it into position. The inch feature enables the
operator to jog the servo feed forward or reverse at a slow rate. The operator
can select jog to length or jog continuous to aid in threading up material.
The Rapid-Air Servo Roll Feed has been designed to mount on a free
standing table as close as possible to the cutter.
The precision mechanical roll feed unit has been designed for compactness
and ease of setup and installation. Three cables with twist lock connectors,
two cables for the servo and one connected to the cutter including one air line
are the only external connections required. The electrical controls are housed
in a small cabinet which have been mounted close to the working area. The
operator keypad and display are mounted on top of the control cabinet.
INSTALLATION AND MECHANICAL SETUP OF SERVO AND CUTTER
file:///C|/Web_develop/cut_to_length_with_multi_stroke_.htm (6 of 66) [12/10/2001 3:44:57 PM]