Rapid-Air CUT-TO-LENGTH WITH MULTI-STROKE - Manual (Page 38)

Cut to Length with Multi Stroke Program
You may not without expressed permission from Rapid-Air:
A. Copy, distribute, or document the program for others.
B. Modify or merge any portion of the program for use on non compatible
hardware.
C. Make alterations to the program.
OPERATOR INPUT TERMINAL - PROGRAMMING PROCEDURE-
STANDARD SOFTWARE
The intent of this section is to familiarize the operator with the program flow
and what to expect with every keypress. Each screen on the display will be
reviewed with special comments to help clarify what is being asked on the
screen. The program flow is broken down into 5 sections with the main menu
being the home postion. Reviewing the flow chart in the back of this manual
will help in understanding the sections.
SECTION1 —- F1=JOB ENTRY
SECTION2 —- F2=MANUAL MODE
SECTION3 —- F3=AUTOMATIC
SECTION4 —-F4=REVIEW JOB PARAMETERS
SECTION 5 —-RAMP=ADJUST ACCELLERATION AND DECELLERATION
file:///C|/Web_develop/cut_to_length_with_multi_stroke_.htm (37 of 66) [12/10/2001 3:44:58 PM]