Mediabridge MWN-WAPR150N User Guide - Manual (Page 19)

MWN-WAPR150N Wireless Router v11.8
19
 If you cannot access the internet and you do
not have access to your Modem, see instructions
under “2.1b No Modem Access”
 If you cannot access the internet and you have
a Residential Gateway, Router, or Wireless
Modem try changing the IP address of the Medialink
router (see Section 2.2 Page 28) or Configure the
Medialink router as a Wireless Access Point instead
(see Section “2.3 Router to Router Configuration” on
Page 48)
 If you are sure that your device is a simple
cable modem with no routing function, your
Internet Service Provider may require that
your router clones the MAC address of your
computer (see instructions below)
Open an Internet Browser (you won’t have access to
the internet but you just need the browser). In the
address bar of your internet browser, type
http://192.168.0.1 then when prompted, enter the
Username: admin Password: admin. In the menu to
the left, Click “Advanced Settings” then Click “MAC
Address Clone”. Click “Clone MAC Address”, Click
“Apply”, then Click “OK” to start the reboot. After the
router reboots, confirm access to the internet.
 If you still cannot access the internet and it is