Mediabridge MWN-WAPR150N User Guide - Manual (Page 84)

MWN-WAPR150N Wireless Router v11.8
84
Primary Router Configuration
 IP Adress: 192.168.0.1
 Subnet Mask: 255.255.255.0
 WLAN SSID: Your Choice
 WLAN Security: Your Choice
 Broadcast Channel: Your choice (default is 6 )
 Channel Extension: Your choice (default is 10)
 WDS Mode: Lazy
 WDS Encrypt: None
 DHCP Server: Enabled
 Prevent Network Attack (Firewall): Enabled
Secondary Router Configuration
 IP Address: 192.168.0.X (last digit different than Primary)
 Subnet Mask: 255.255.255.0
 WLAN SSID: Your Choice (make it different from Primary
Router so you can tell the routers apart)
 WLAN Security: Your Choice (doesn’t have to be the same
as Primary Router, but it is recommended so you can
remember it easily)
 Broadcast Channel: 6 (these channels don't have to be 6 but
it has to match Primary Router)
 Channel Extension: 10 (Same thing. doesn't have to be 10
but has to match Primary Router)
 DHCP Server: Disabled
 Prevent Network Attack (Firewall): Disabled
 Lazy: Use this mode on the primary router connected
directly to the ISP (modem) when additional routers are
used as additional access points. The secondary routers
must be set to “Bridge” or “Repeater” when this option is
selected.