Mediabridge MWN-WAPR150N User Guide - Manual (Page 85)

MWN-WAPR150N Wireless Router v11.8
85
 Bridge: This setup is used for when you want to plug a
device in the secondary router and have the secondary
router wirelessly connect to the primary router. Setup a
secondary router as a wired or wireless access point.
Connect an Ethernet cable to the LAN port of the
Secondary router. (Primary router must be set to
“Lazy”). Click “Open Scan” and select the MAC address
of the Primary router to connect the two devices and
establish a wider network.
 Repeater Mode ： Setup a secondary router as a
Wireless Access Point. (Primary router must be set to
“Lazy”). Click “Open Scan” and select the MAC address
of the Primary router to connect the two devices and
establish a wider network.
 Encrypt Type: Select one from WEP, TKIP, AES for
security here. (Note: It is recommended to leave this
disabled and only use the Wireless Security Settings
instead.)
 Pass phrase: Enter the encrypted key for wireless
devices. (Note: It is recommended to leave this
disabled and only use the Wireless Security Settings
instead.)
 AP MAC: Input the MAC address of another (opposing)
wireless router you want to connect.
 Reboot the Router: Click “System Tools->Reboot”
when finished configuring WDS.