Mediabridge MWN-WAPR150N User Guide - Manual (Page 40)

MWN-WAPR150N Wireless Router v11.8
40
2.2a ADSL Virtual Dial-Up via PPPoE
(For users that have a Username and
Password to connect via DSL)
If you were not successful in setting up the router after
Section 2.2 or if you know that you need to enter your DSL
Account username and password to establish an internet
connection – continue with the additional instructions below:
1. Connect Your Medialink Router (Figure 2.1)
a. Plug a network cable from your DSL modem
into your Medialink Router’s BLUE WAN Port.
b. Using another network cable, plug one end
to your computer’s network port. Plug the
other end into one of the Medialink Router’s
YELLOW ports numbered 1, 2, 3, or 4. (It
is not required to connect a computer to the
router at this point. But it is highly
recommended for faster setup of your
wireless network. Once setup is complete,
you may then unplug the computer and
connect wirelessly.)
c. Power On your Medialink Router - Connect the
AC/DC Adapter to the router’s Power port.
Connect the other end into an electrical
outlet. Wait 30 seconds to allow