Triton RL5000 Installation Manual - Manual (Page 16)

1 6
ATM E
NVIRONMENTAL
P
RECAUTIONS
C
HECKLIST
TEMPERATURE/HUMIDITY
1. The ATM needs to be in an envi-
ronmentally-controlled location,
with no extreme fluctuations in
temperature or humidity.
Generally, these parameters must
fall within the following ranges:
Temperature
•
10-40 Deg. C
• 50-104 Deg. F
Relative Humidity
•
20% - 80%
• (Non-Condensing)
AC POWER REQUIREMENTS
2. Ensure the following AC power
requirements are met:
"
"
Isolated Ground. An equipment ground-
ing conductor that is insulated from the
conduit or raceway and all other
grounding points throughout its entire
length. The only points of electrical con-
nection will be at the duplex outlet and
service panel ends of the line.
When installing an ATM, some general environmental precautions need
to be considered. Evaluate the location where the ATM will be installed.
To help ensure proper operation of the ATM, ensure the environmental
criteria listed in this checklist are met.
Dedicated source. The ATM AC power
feed will be a dedicated line, to which
no other electrical devices are con-
nected. The ATM power line will be
wired for a single “duplex”-style outlet
and connected directly to the AC ser-
vice panel.
DEDICATED TELEPHONE
3. Ensure the following telephone-
line requirements are met:
Dedicated line. The telephone line ser-
vicing the ATM will not be a “party”
line or any other shared type connec-
tion.
Proximity to Interference Sources. The
telephone line must not be in close prox-
imity to “noisy” devices that could in-
duce interference into the ATM com-
munications channel. See the next sec-
tion for addtional information on “inter-
ference sources.”
RF INTERFERENCE
4. Ensure there are no devices near
the terminal that may cause RF in-
terference, such as:
" TVs " Coolers
" Security Devices
" Neon Signs
" Devices with Compressors
Refer to the Service Manual for in-
formation on ATM physical, electri-
cal, and environmental specifica-
tions.