Triton RL5000 Installation Manual - Manual (Page 40)

4 0
RL5000 S
ERIES
I
NSTALLATION
G
UIDE
I
NSTALLING THE
TDM-100/150
D
ISPENSING
M
ECHANISMS
1. Refer to Figure 1. Unlock and open
the control panel. Verify that the
power switch is in the OFF (0)
position. Close the control panel.
2. Remove the packing material from
the ends of the dispenser data and
power cables that are hanging
inside the cabinet. (Figure 2)
Figure 2. Dispenser data and power
cables.
3. Unpack and remove the dispensing
mechanism from its shipping
container. Remove the currency and
reject cassettes from the dispenser.
4. Open the security cabinet and slide
the dispenser tray out to its fully
extended position. Check the
position of the turntable. The
turntable must be in the cassette
service position to correctly install
the dispensing mechanism. The
turntable is in the service position
when the 90° locking pin hole is to
the left as shown in Figure 3. It is in
the normal operating position
when the hole is to the right as
shown in Figure 4.
Figure 3. Turntable in cassette
service position. Note that plate hole
is to the left.
Figure 4. Turntable in operating
position. Note that plate hole is to
the right.
Four, 6-32 x 5/16 screws (02054-00098)
are required to attach the dispensing
mechanisms to the turntable. The
screws are provided in the ATM ac-
cessory box.
Figure 1. Power switch on left side of
power module.