Triton RL5000 Installation Manual - Manual (Page 48)

4 8
10. Install currency in the cassette and
insert into the dispensing
mechanism. Refer to Section 4,
Cash Replenishment, in the
RL5000 User manual for detailed
information about handling
cassettes.
**CAUTION**
Make sure the cassette is primed
and the window below the lock
displays green before installing
the cassette. Attempting to install
an unprimed cassette into a
dispensing mechanism may
damage the cassette and void its
warranty.
11. Open the control panel and apply
AC power to the ATM by pushing
the AC power switch to the ON (1)
position.
12. Complete the ATM setup, if
necessary, according to the
instructions in the RL5000
Configuration manual or applicable
Service manual.
13. Follow the remaining steps to
perform a Test Dispense:
b. Select Diagnostics from the
Management Functions screen,
then Dispenser.
c. Select the Test Dispense option.
Select cassette “A”. A prompt
appears asking how many notes to
dispense. (Figure 5) The Test
Dispense operation will start.
RL5000 S
ERIES
I
NSTALLATION
G
UIDE
a. Access the Management Functions
main menu screen. Refer to RL5000
User Manual for instructions on
accessing the Management
Functions main menu.
Figure 5. Enter # of notes.
d. The Test Dispense command
instructs the dispenser to
dispense, minimum, one note from
the the note Cassette into the reject
tray of the cassette. This test
exercises the dispenser without
sending notes to the exit.
e. After completion of the Test
Dispense operation, the following
prompt is displayed - “Test
Dispense Completed Successfully
- Dispense Count, A: (# of notes)”.
(Figure 6)
Figure 6. Test dispense prompt.