Triton RL5000 Installation Manual User Manual
Page 32
3 2
RL5000 S
ERIES
I
NSTALLATION
G
UIDE
2.
Use an adjustable crescent or
ratchet wrench with 18 mm (3/4")
socket to tighten the nuts down.
No minimum torque setting for the
nuts is required. Simply ensure the
nuts are tightened down firmly
enough to secure the ATM cabinet
to the anchors. Tightening the nuts
just beyond hand tight should
prove adequate.
3.
Once all anchors are tightened,
close the door of the cabinet to
ensure that the door does not bind.
If the door does bind, loosen the
anchor nuts slightly and retighten
them in the following sequence:
a.
Back left
c.
Left front.
b.
Right front
d.
Back right
Fig. 8. Tighten nuts with wrench.
4.
Close the door and check for proper
operation. The leveling feet may
need to be adjusted to re-square
the cabinet after the anchor nuts
have been retightened.If the door
continues to bind, it may be
necessary to relocate the cabinet
to an area with a flat level floor!
5.
Once the cabinet is square (level)
and the door operates without
binding, install a second nut on
each bolt and tighten down firmly.
6.
If the dispenser tray was removed
to facilitate cabinet installation,
replace it at this time.
Fig. 9. Add second (jam) nut and
tighten.