Triton RL5000 Installation Manual - Manual (Page 28)

2 8
RL5000 S
ERIES
I
NSTALLATION
G
UIDE
CHEMICAL ANCHOR SYSTEM
The chemical anchor installation
system used in this procedure
bonds threaded anchor-rod inserts
to the base material (for ATM appli-
cations this is typically a concrete
foundation). Unlike traditional ex-
pansion-bolt anchoring systems,
chemical anchoring is accom-
plished without exerting expansion
forces against the base material. As
a result, the chemical anchoring
system proves ideal for anchoring
in a wider selection of materials from
brick to granite.
MARK/DRILL
MOUNTING HOLES
Mark the location of the cabinet
mounting holes on the concrete floor.
This can be accomplished in two ways
as described below:
1a. Preferred Method. Place the
included mounting hole drilling
template on the floor in the
designated location and tape it into
position. Be certain there are no
physical obstructions that could
prevent the cabinet from being
installed in this location or
otherwise limit access to the unit!
Use a center punch tool (or
equivalent) to mark the center of
each mounting hole as indicated
on the template. Remove the
template.
1b. Alternative Method (Business
Hours Units). Move the ATM to
the location where it will be
installed.
Open the cabinet door at least 90°
degrees to improve access. Locate
the four anchor-bolt holes
(cutouts) in the bottom of the
cabinet. Use a felt-tip pen or other
marker to carefully mark the center
of each of these four holes on the
floor; these marks will serve as
guides for the anchor bolt holes
that will be drilled in the next step.
Move the ATM aside, to provide
clear access to the mounting hole
marks.
Fig. 1. Drilling mounting holes.