Triton RL5000 Installation Manual - Manual (Page 6)

6
RL5000 S
ERIES
I
NSTALLATION
G
UIDE
What’s in This Installation Guide
This Installation Guide gives step-by-step procedures for completing the physical
installation of a Triton RL5000. This guide covers cabinet and dispenser installa-
tion for RL5000 series units equiped with TDM-100/150, SDD, or NMD-50 dispens-
ing mechanisms. The Installation Guide is divided into the following sections:
!
Introduction. Summarizes the basic steps that must be completed to physically
install an RL5000 ATM for specified dispenser mechanisms noted above. Note:
Configuration of operating parameters is not covered! Refer to the applicable
Configuration and/or Service Manual for instructions on configuring the
operating parameters.
!
ATM Installation for Accessibility. Describes the basic Americans with
Disabilities Act (ADA) requirements for ATM location and access. Note: These
are the general requirements that should be applicable to most installation
locations. Please verify the specific requirements with the state where the ATM
is to be installed prior to installation. For state contact information, you may call
the ADA information line at 1-800-514-0301.
!
ATM Environmental Precautions Checklist. Describes the general
environmental precautions considered when installing the ATM. To help ensure
proper operation of the ATM, ensure the environmental criteria listed in this
checklist are met.
!
Cabinet Installation - Standard Anchors. Describes how to install the ATM
cabinet using standard (steel) anchor bolts.
!
Cabinet Installation - Chemical Bolts. Describes how to install the ATM cabinet
using a chemical anchoring process. Note that to install the cabinet according
to these instructions you must purchase the optional chemical anchor install kit
(Part Number 06200-00060).
!
Power and Communication. Describes how to connect the ATM to the facility
power and telephone connections.
!
Dispensing Mechanism Installation. Describes how to install the NMD-50
dispensing mechanisms into the ATM security cabinet.
!
TCP/IP (Ethernet) Cable Installation. Describes where to install the 10Base-T
Cat-5 cable to the unit’s docking board assembly.
!
VSAT Cable Installation. Describes where to install the optional VSAT cable.