Triton RL5000 Installation Manual - Manual (Page 46)

4 6
I
NSTALLING THE
SDD
D
ISPENSING
M
ECHANISM
The SDD dispensing mechanism is
shipped inside the cabinet of the
RL5000 security cabinet in its own
container. Remove it from inside the
cabinet before the ATM is bolted to the
floor.
1. Refer to Figure 1. Unlock and open
the control panel. Verify that the
power switch is in the OFF (0)
position. Close the control panel.
2. Remove the packing material from
the ends of the dispenser data and
power cables that are hanging
inside the cabinet.
3. Unpack and remove the ATM
mechanism from its shipping
container.
4. Pull the cassette tray out to its fully
extended position as shown in
Figure 2.
5. Pick up the dispensing mechanism
and place it on the cassette tray.
Leave enough room to easily
access the back of the dispensing
mechanism so it can be connected
to the cables coming from the
ATM.
6. Refer to Figure 3. Connect cable
9600-0043 to the DB25 connector
(PL6) on the rear of the dispenser
mechanism. Secure the DB25 cable
to the dispenser with two screws
attached to the connector. Insert
the Molex power plug attached to
cable 9600-0013 into the connector
marked PL2. This plug is keyed so
that it can only be inserted in one
direction.
7. Refer to Figure 4. Install the
dispensing mechanism by sliding
the end with the circuit board into
the tray in the cabinet. The
mechanism should slide under two
tabs in the rear and the front edge
slots should align with the two
bolts provided with wing nuts.
Once the mechanism is fully
engaged into the tray, tighten the
wing nuts by hand.
Figure 2. SDD dispenser tray pulled
out to extended position.
RL5000 S
ERIES
I
NSTALLATION
G
UIDE
Figure 1. Power switch on left side of
power module.