Triton RL5000 Installation Manual - Manual (Page 52)

5 2
7. Refer to Figure 8. Connect the se-
rial communication cable to the
CMC module on the dispensing
mechanism. Make sure to run the
cable through the guides that have
been provided on the mechanism
cover.
8. Push the dispensing mechanism all
the way into the cabinet.
Figure 8. Connect the serial
communication cable to the
dispensing mechanism as shown.
(Forward-most connector)
RL5000 S
ERIES
I
NSTALLATION
G
UIDE
5. Pull the dispensing mechanism out
of the cabinet to the mechanical
stops.
6. Refer to Figure 7. Connect the DC
power cable to the Central Machine
Controller (CMC) module on the
dispensing mechanism.
3. Refer to Figure 6. Align the rails on
the dispenser with the openings on
the slide mechanisms on both
sides of the cabinet. Once aligned,
carefully push the dispensing
mechanism on to the slides.
4. Push the dispensing mechanism all
the way into the cabinet.
Serial communication cable
9. Install currency in the cassette and
insert and it into the dispensing
mechanism. Refer to Section 4,
Cash Replenishment, in the
RL5000 User Manual for detailed
information about handling
cassettes.
10. Open the control panel and apply
AC power to the ATM by pushing
the AC power switch to the ON (1)
position.
11. Complete the ATM setup, if
necessary, according to the
instructions in the RL5000
Configuration manual or applicable
Service manual.