Triton RL5000 Installation Manual - Manual (Page 51)

5 1
7. Grasp the dispensing mechanism
by the green handles and pull it
out of cabinet until it is clear of the
slides.
8. Place the dispenser in a safe loca-
tion where it will not get accidently
damaged.
9.* If installing the cabinet at this time,
follow the procedures provided on
pages 18 through 24 or pages 26
through 34 of this manual.
I
NSTALLING THE
NMD-50 D
ISPENSING
M
ECHANISM
I
NTO
T
HE
C
ABINET
1. Refer to Figure 5. Push the slides
completely into the cabinet. Make
sure all cables have been moved
out of the way so they will not be
damaged while installing the dis-
pensing mechanism in the cabinet.
2. Pick up the dispensing mechanism
by the green handles.
Figure 5. Push the rails into the
cabinet before installing the
dispensing mechanism into the
cabinet
Figure 6. Align the rails on the
dispenser with the openings on the
slide inside the cabinet.
Figure 7. Connect the DC power plug
to the receptacle shown above.
NMD-50 D
ISPENSING
M
ECHANISM
I
NSTALLATION
4. Refer to Figure 2. Pull the dispens-
ing mechanism out of the cabinet
until it reaches the mechanical
stops on the mounting rails.
5. Refer to Figure 3. Disconnect the
DC power and serial communica-
tion connectors from the dispens-
ing mechanism.
6. Refer to Figure 4. Release the me-
chanical stops (one located on each
side of the rail mechanism) by push-
ing “in” while at the same time pull-
ing the dispensing mechanism out
another inch.
Rail
Slide
Connect DC power
receptacle