Triton RL5000 Installation Manual - Manual (Page 41)

4 1
TDM-100/150 D
ISPENSING
M
ECHANISM
I
NSTALLATION
5. If the turntable is not in the service
position, pull down on the
turntable locking pin on the
underside of the tray as shown in
Figure 5 and rotate the turntable
clockwise until it is in the service
position as shown in Figure 6.
Release the locking pin to lock the
turntable in the replenishment
position.
Figure 5. Location of turntable
release pin on underside of dispenser
tray.
Operating Service
Figure 6. Rotate turntable
6. Refer to Figure 7. Place the
dispensing mechanism on the
turntable in the cassette service
position (with the opening for the
currency and reject cassettes
facing to the front as you look into
the security cabinet).
Figure 7. Dispenser on swivel
mount in cassette service position.
7. Refer to Figure 8. Align the four
holes in the base of the dispensing
mechanism with the four holes in
the turntable flanged edges. Secure
the dispensing mechanism to the
turntable with the four, #6-32 x x5/
16 screws supplied in the ATM
accessory kit.
8. (For TDM-100) Rotate the
dispenser 90° counter-clockwise.
Route the serial communications
cable and power cable through the
tie-wrap loop and plug the data
cable into jack J11. Plug the DC
power connector into jack J12
(Figure 9). Pull tie wrap to secure
cables to dispenser.
Figure 8. Location of dispenser
mounting holes.