AW Gear Meters MX 9000 - Manual (Page 18)

MX 9000 Process Monitor
Operation and Programming Manual
17
MX 9000 User Manual, Rev. 2.0 7/16/2013
LOGO screen
The LOGO screen shows 3 or 4 lines of important data for the display unit which is needed if contacting
the factory for support issues.
1. Line 1 shows the basic model name
2. Line 2 shows the unique serial number of the unit.
3. Line 3 shows the firmware version of the unit
4. Line 4 shows the firmware version of the HART protocol. NOTE: Line 4 will only show if the
unit was purchased with the HART protocol option
Pushing the SELECT button on the LOGO screen will show the actual model number of the MX 9000. As
the features vary with the model, please make a note of this while reading through this manual.
RATE screens
The RATE screen displays the flow rate of A or B in the programmed engineering units. If the linearizer is
active, ‘LN’ shows in lower left corner. If the Gate Time filter is active, ‘GT’ shows in lower right corner.
TOTAL / GRAND TOTAL screens
The TOTAL screen displays the flow total of A or B in programmed engineering units. Pressing the RESET
button resets the value back to zero (0). The Total can also be reset remotely by connecting a
momentary voltage to the external RESET input.
Figure 1: RATE screen
Figure 2: TOTAL screen
MX 9000
S/N 0000000
Software Version 1.0.0
HART SW Version 1.0.0
TOTAL A(B)
6000 GAL
RATE A(B)
600.00 GPM
GRAND TOTAL A(B)
6000 GAL