Fine ma adjustment, Coarse ma adjustment, Frequency adjustment – AW Gear Meters MX 9000 User Manual
Page 36: Fine limit output adjustment, Mx 9000 process monitor
MX 9000 Process Monitor
Operation and Programming Manual
35
MX 9000 User Manual, Rev. 2.0 7/16/2013
Fine mA adjustment
Figure 29: Fine mA Adjustment
When you
SELECT
the Fine adjustment option, the screen above will appear which shows the active mA
output value. Change this number to any desired value between 2.00mA and 20.00mA and when
ENTER
button is pressed, the MX 9000 will output this value. This also returns the screen to the adjustment
type screen. Press
SELECT
to see output value again and make new change.
Coarse mA adjustment
Figure 30: Coarse mA Adjustment
When choosing the Coarse adjustment option, the screen will appear where the mA output value can be
changed. When pressing the
UP
button, the screen value (and mA output value) increments by 1mA, to
a max of 20mA. When pressing the
DOWN
button, the screen value (and mA output value) decrements
by 1mA to a min of 2mA. This is the fastest way to test the mA output range if no specific mA output
value is required. Press the
EXIT
button to leave this mode.
Frequency Adjustment
The Frequency output (available on option boards 1 and 2) can be manually controlled to change states
using one of 3 methods. The fine adjustment allows the user to enter a specific frequency to output
between 2Hz to 4,500Hz. The coarse adjustment allows the user to output a frequency and change the
rate in 25Hz increments using the
UP
and
DOWN
buttons. The ON/OFF adjustment allows the user to
individually toggle the output state between on and off using the
SELECT
button.
Fine limit output adjustment
Figure 31: Fine limit output adjustment
When choosing the Fine adjustment option, the screen will appear which shows the active frequency
output value on the Frequency output. Change this number to any desired value between 2Hz and
4,500Hz and when
ENTER
button is pressed; the MX 9000 will output this value frequency output. This
also returns the screen to the adjustment type screen. Press
SELECT
to see output value again and make
new change.
> Fi ne Adjustment
Coa rs e Adjustment
Enter mA Value
To Output
Output = 04.00 mA
Fi ne Adjustment
> Coa rse Adjustment
Use UP/DOWN Keys to
change output in 1mA
incerments
Output = 04.00 mA
> Fi ne Adjustment
Coa rs e Adjustment
ON/OFF adjustment
Enter frequency value
To Output
Output = 0000.00 Hz