AW Gear Meters MX 9000 - Manual (Page 41)

MX 9000 Process Monitor
Operation and Programming Manual
40
MX 9000 User Manual, Rev. 2.0 7/16/2013
Batch Controller Programming
The batch controller model enables functions not found on the regular models and is factory configured
with a special option board to support these added functions. Instead of just one batch set point found
in the standard model, the batch controller adds 19 more for a total of 20 batch presets. Most
important are the 5 remote control line inputs which enable the electronics to select and process the 20
pre-programmed batch quantities.
The following section only applies to models MX9-B that were shipped programmed as a batch
controller. All other units contain only one batch function as shown on page 38. Remote control
functions are also only available on the batch controller model.
Basic programming setup
The basic controller setup is accomplished in an identical manner as a standard MX-9000 monitor for
such things as K-Factor, analog output, gate time and linearizer. Refer to the programming sections
earlier in this manual for the procedures on how to accomplish this.
BATCH Programming
Batch programming of the 20 presets must be done using the external inputs along with the front panel
pushbuttons. It is not possible to program the monitor using just the front panel pushbuttons. A
programming signal must be present on the Program / Run input to enable the programming capability.
The batch select input is also utilized during this function.
To set the individual batch programs, set the Program / Run switch to the “Program” position. Use the
Batch Select switch to select the batch number to change. It is NOT necessary to program the batches in
sequential order – you can program any number of them skipping around the 20 available presets.
Any batch entry that is not programmed will not appear in the RUN mode. Only programmed batches
will show when scrolling through the available numbers.
Notice
Notice