Canon imagePROGRAF iPF9400S User Manual
Page 375
A
Media Type
The paper selected with Media Type of the Main panel is displayed.
For information on the types of paper the printer supports, refer to the Paper Reference Guide. (See " Paper Reference
Guide
".)
B
Drying Time
Specify the time that the printer waits for ink to dry, as needed. The Drying Time setting is only valid for rolls.
•
C
Between Pages
You can set the time to wait after printing 1 document page until ejecting the paper. Since waiting time is required
for ink to dry before a roll is cut, you can deliver paper in the Output Stacker with the ink dried even if Cutting
Mode is set to Automatic.
Setting Item
Details
Printer Default
The setting of the control panel of the printer is applied.
None
Paper is ejected immediately after printing completes.
30 sec. / 1 min. / 3 min. / 5 min. / 10
min. / 30 min. / 60 min.
Paper is ejected when the set time elapses after printing completes.
•
D
Between Scans
You can set the time to wait after printing 1 line on a page until printing the next line. Set this to avoid bleeding or
color unevenness such as when bleeding occurs on a page or when color unevenness occurs during borderless
printing.
Setting Item
Details
Printer Default
The setting of the control panel of the printer is applied.
None
The next line is printed immediately after a line is printed.
1 sec. / 3 sec. / 5 sec. / 7 sec. / 9 sec.
The next line is printed when the set time elapses after a line is printed.
* Increase the time according to the occurrence condition of bleeding or unevenness.
E
Roll Paper Margin for Safety
You can specify the length of a margin on the leading edge of paper to ensure that paper susceptible to curling is held
firmly against the Platen.
•
F
Near End Margin
Specify the length of the Near End Margin (the leading edge margin) of the roll, as needed.
Setting Item
Details
Printer Default
The setting of the control panel of the printer is applied.
5 mm (0.2 in)
The document is printed in the standard size.
* Select this when you do not have any problems in printing.
20 mm (0.8 in)
Select this when rubbing against the printhead occurs such as when using paper that tends to
curl.
G
Cut Speed
Select the speed of automatic cutting, as needed. You can adjust this setting if paper is not cut well when automatic
cutting is used.
Setting Item
Details
Printer Default
The setting of the control panel of the printer is applied.
High Speed
When the Standard setting does not result in a clean cut surface, select this.
Standard
Select this when you do not have any problems in automatic cutting.
iPF9400S
Paper Detailed Settings Dialog Box (Mac OS X)
Mac OS X Software
Printer Driver
375