Insufficient paper for job, This paper cannot be used as size is not supported – Canon imagePROGRAF iPF9400S User Manual

Page 921

Advertising

Cause

Corrective Action

If this error recurs after you reload the roll, re-
move the Roll Holder from the printer, push the
roll firmly in until it touches the Roll Holder
flange, and reload the Roll Holder in the print-
er.
(See "Attaching the Roll Holder to Rolls.")

→P.538

Because the Platen is soiled with ink or other substances, the size of the clear film cannot
be detected.

Open the Top Cover and clean the entire Plat-
en.
(See "Cleaning Inside the Top Cover.")

→P.869

Insufficient paper for job

Cause

Corrective Action

The printer has received a print job longer than the amount of roll paper left when ManageR-
emainRoll in the Control Panel menu is On.

Press ▲ or ▼ to select Print, and then press
the OK button to resume printing.
When using the Media Take-up Unit, press ▲
or ▼ to select Print, and then press the OK
button to resume printing.
However, the roll paper may run out during the
print job and you may not be able to print all of
the document.

Press ▲ or ▼ to select Change Paper, and
then press the OK button.
Change the Paper Source of the printer driver,
or replace the roll with a roll that has enough
paper for the print job, and then printt.
When using the Media Take-up Unit, press ▲
or ▼ to select Stop Printing, and then press
the OK button to stop printing.
Remove the printed document from the Media
Take-up Unit, replace the roll with a roll that
has enough paper for the print job, and then try
printing again.
(See "Removing the Roll from the Printer.")